Test Weight Specifications and Calibration
Specifications
-
Meets density requirements
-
Exterior: Cast iron construction. All edges and corners rounded
- no sharp angles.
-
Recessed lifting eye
-
Side mount cavity: 2 inch inside diameter with backup disk and sealing
cap. 10 pound capacity lead shot
-
Paint: One coat flat (AL) primer
-
Capacity lettering in casting
Calibration
-
Substitution Method
Note: For official status, weights have to be certified by a state
metrology lab.
-
Serial Number is stamped on the top of the weight for a permanent record
(upon request)
-
Calibration Reports available
-
Sealed to Class F tolerances, 1 part in 10,000.
-
Maximum weight capacity at most labs is 3000 pounds. Larger Capacities
can be tested in Texas, Illinois, California and New York.
Check out more information on Test
Weights
For more information, contact Bernie Lamb at 800-335-3026 or 651-646-8277
or fax at 651- 641-7234
Or contact Allied Equipment Sales by email at blamb@allied-equipment.com
Allied Equipment Sales, Inc.
1821 University Ave
Suite 171 N.
St. Paul, Minnesota
55104
USA
Contact us for our drawings showing all details for our
recommendations to fulfill the needs on your job.